User:Cwood1212/Drainage basin
![](http://up.wiki.x.io/wikipedia/commons/thumb/0/06/Alaska_level_4_hydrologic_units.jpg/220px-Alaska_level_4_hydrologic_units.jpg)
Hydrology
[edit]In hydrology, the drainage basin is a logical unit of focus for studying the movement of water within the hydrological cycle,[1] because the majority of water that discharges from the basin outlet originated as precipitation falling on the basin. A portion of the water that enters the groundwater system beneath the drainage basin may flow towards the outlet of another drainage basin because groundwater flow directions do not always match those of their overlying drainage network. Measurement of the discharge of water from a basin may be made by a stream gauge located at the basin's outlet. Depending on the conditions of the drainage basin, as rainfall occurs some of it seeps directly into the ground. This water will either remain underground, slowly making its way downhill and eventually reaching the basin, or it will permeate deeper into the soil and consolidate into groundwater aquifers.[2]
As water flows through the basin, it can form tributaries that change the structure of the land. There are three different main types, which are affected by the rocks and ground underneath. Rock that is quick to erode forms dendritic patterns, and these are seen most often. The two other types of patterns that form are trellis patterns and rectangular patterns.[3]
Rain gauge data is used to measure total precipitation over a drainage basin, and there are different ways to interpret that data. If the gauges are many and evenly distributed over an area of uniform precipitation, using the arithmetic mean method will give good results. In the Thiessen polygon method, the drainage basin is divided into polygons with the rain gauge in the middle of each polygon assumed to be representative for the rainfall on the area of land included in its polygon. These polygons are made by drawing lines between gauges, then making perpendicular bisectors of those lines form the polygons. The isohyetal method involves contours of equal precipitation are drawn over the gauges on a map. Calculating the area between these curves and adding up the volume of water is time-consuming.
Soil type
[edit]Soil type will help determine how much water reaches the river. The runoff from the drainage area is dependent on the soil type. Certain soil types such as sandy soils are very free-draining, and rainfall on sandy soil is likely to be absorbed by the ground. However, soils containing clay can be almost impermeable and therefore rainfall on clay soils will run off and contribute to flood volumes. After prolonged rainfall even free-draining soils can become saturated, meaning that any further rainfall will reach the river rather than being absorbed by the ground. If the surface is impermeable the precipitation will create surface run-off which will lead to higher risk of flooding; if the ground is permeable, the precipitation will infiltrate the soil.[2]
![]() | This is the sandbox page where you will draft your initial Wikipedia contribution.
If you're starting a new article, you can develop it here until it's ready to go live. If you're working on improvements to an existing article, copy only one section at a time of the article to this sandbox to work on, and be sure to use an edit summary linking to the article you copied from. Do not copy over the entire article. You can find additional instructions here. Remember to save your work regularly using the "Publish page" button. (It just means 'save'; it will still be in the sandbox.) You can add bold formatting to your additions to differentiate them from existing content. |
Article Draft
[edit]Lead
[edit]Article body
[edit]References
[edit]- ^ "drainage basin | Definition, Example, & Facts". Encyclopedia Britannica. Retrieved 2021-09-22.
- ^ a b "Watersheds and Drainage Basins". www.usgs.gov. Retrieved 2021-09-22.
- ^ Earle, Steven (2015-09-01), "13.2 Drainage Basins", Physical Geology, BCcampus, retrieved 2021-09-22