Jump to content

United Aircraft

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Three-quarter-ten (talk | contribs) at 01:32, 27 September 2017 (Restore this sentence—whoever changed it failed to understand the point, i.e., that before there was a C-5 or a 747 specifically, there was an RFP for "big honkin aircraft"—C-5 and 747 were the instances that eventually won.). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

United Aircraft Corporation
IndustryAerospace
PredecessorUnited Aircraft and Transport Corporation
Founded1934
SuccessorUnited Technologies Corporation
Headquarters,
Key people
Frederick Rentschler, founder; George J. Mead, senior engineer

The United Aircraft Corporation was an American aircraft manufacturer formed by the break-up of United Aircraft and Transport Corporation in 1934. In 1975, the company became the United Technologies Corporation.

History

Pre-1930s

1930s

The Air Mail scandal of the early 1930s resulted in a rebuilt air mail system, under the Air Mail Act of 1934, in which carriers and their equipment manufacturers (e.g., of airframes and engines) could no longer be owned by the same company.[1] The United Aircraft and Transport Corporation was broken up as a result of this new law. The corporation's airline interests went on to become United Airlines. Its manufacturing interests east of the Mississippi River--Pratt & Whitney, Chance Vought, and Sikorsky—remained together as the new United Aircraft Corporation, headquartered in Hartford with Frederick Rentschler, founder of Pratt & Whitney, as president. All manufacturing interests west of the Mississippi became part of a revived Boeing Aircraft.[1][2]

The latter half of the 1930s saw military procurement buildups around the world as governments foresaw possible war on the horizon. United Aircraft sold to both the United States Army and the United States Navy, but the Navy's requirements for carrier-based aircraft, with maximized power-to-weight ratios for minimized takeoff runway length, were always more in tune with the specialties of United's subsidiaries (Pratt & Whitney, Chance Vought, and Sikorsky).[1]

United Aircraft became a component of the Dow Jones Industrial Average on March 4, 1939, when United Aircraft and AT&T were added to replace Nash Motors and International Business Machines. United Aircraft, subsequently known as United Technologies, has remained a component of the Dow Jones Industrial Average since that time.

1940s

For the subsidiaries of United Aircraft, and for countless other manufacturing firms, World War II was an exercise in how to attempt to meet limitless demand for production (as well as for R&D).[3][4] The U.S. government encouraged corporations to build up their physical plant, but the corporations knew that there would be a postwar glut of overcapacity if they did so. In many cases a compromise was reached in which the government paid partially or fully for the expansions in the form of tax breaks and accelerated depreciation.[1]

United Aircraft ranked sixth among United States corporations in the value of wartime production contracts.[5] At the close of the war, jet engines and helicopters were both big new things whose coming growth many companies hoped to get in on. United Aircraft entered both industries, via Pratt & Whitney and Sikorsky, respectively.[1]

1950s

Pratt & Whitney feared the head start that Rolls Royce and General Electric would have in jets, based on their jet programs during the war and the late 1940s. But its jet team, led by Leonard S. Hobbs, successfully developed the Pratt & Whitney J57, which, being the most powerful jet engine on the market for some years, brought Pratt & Whitney profitability in the jet field.[1]

Vought was spun off as an independent business in 1954. Rentschler died two years later.

1960s

The 1960s brought new challenges, from more complex technology and bigger, more expensive aircraft to more mature markets with stiffer competition from GE, Rolls Royce, and SNECMA.[1] The competitions for the requested aircraft that would become the Lockheed C-5 Galaxy and the Boeing 747 were some of the financially riskier episodes.[1] Pratt & Whitney ended up building the engines for the 747, producing the Pratt & Whitney JT9D, but the program was rocky. For several years Boeing and Pratt & Whitney struggled with an aircraft that was too heavy and underpowered.[1] Eventually, after a lot of continued development work, the 747 redeemed itself.

On the military side of the business, the TFX joint-procurement program led to the General Dynamics F-111 Aardvark powered by the Pratt & Whitney TF30.[1]

UAC acquired Chesapeake and Ohio Railway designed UAC TurboTrain to compete in the DOT's Northeast Corridor Demonstration Project. Two trainsets were from 1967-1968 by Pullman for use by Penn Central Transportation Company and later Amtrak for service from 1968 to 1980.

Early 1970s

In the 1970s the jet engine manufacturers found that their products for the commercial (airline) market had been commoditized to a greater extent than in previous decades.[6] Leaving behind a tradition of mating airframes to particular engines (which linked the profitability of an airframe model to that of its exclusive engine supplier), the airframe builders began offering multiple brands of engines.[6][7] Producers had to compete on service, warranties, and eventually even by buying entire aircraft and then leasing them to the airlines.[6]

Diversification and M&A

In 1974, Harry Gray left Litton Industries to become the CEO of United Aircraft.[1] He pursued a strategy of growth and diversification, changing the parent corporation's name to United Technologies Corporation (UTC) in 1975 to reflect the intent to diversify into numerous high tech fields beyond aerospace.[8]

The history of United Technologies Corporation from 1975 forward is discussed at United Technologies Corporation > History.

Business units

See also

References

Notes

  1. ^ a b c d e f g h i j k Fernandez 1983.
  2. ^ Herman, Arthur. Freedom's Forge: How American Business Produced Victory in World War II, p. 6, Random House, New York, NY, 2012. ISBN 978-1-4000-6964-4.
  3. ^ Herman, Arthur. Freedom's Forge: How American Business Produced Victory in World War II, pp. 6, 81 87, 91, 110, 117, 223, 235, 277, 304, Random House, New York, NY, 2012. ISBN 978-1-4000-6964-4.
  4. ^ Parker, Dana T. Building Victory: Aircraft Manufacturing in the Los Angeles Area in World War II, pp. 7-10, Cypress, CA, 2013. ISBN 978-0-9897906-0-4.
  5. ^ Peck, Merton J. & Scherer, Frederic M. The Weapons Acquisition Process: An Economic Analysis (1962) Harvard Business School p.619
  6. ^ a b c Fernandez 1983, pp. 255, 265–266.
  7. ^ Neumann 2004, pp. 229–230.
  8. ^ Fernandez 1983, p. 246.

Bibliography

  • Connors, Jack (2010). The Engines of Pratt & Whitney: A Technical History. Reston. Virginia: American Institute of Aeronautics and Astronautics. ISBN 978-1-60086-711-8.
  • Fernandez, Ronald (1983), Excess Profits: The Rise of United Technologies, Boston: Addison-Wesley, ISBN 9780201104844.
  • Gunston, Bill (2006). World Encyclopedia of Aero Engines, 5th Edition. Phoenix Mill, Gloucestershire, England, UK: Sutton Publishing Limited. ISBN 0-7509-4479-X.
  • Neumann, Gerhard (2004) [1984], Herman the German: Just Lucky I Guess, Bloomington, IN, USA: Authorhouse, ISBN 1-4184-7925-X. A republishing of the 1984 memoir titled Herman the German: Enemy Alien U.S. Army Master Sergeant [Morrow, New York, NY, USA], with a new title but with minor or no textual changes.
  • Sobel, Robert (1972). The Age of Giant Corporations: a Microeconomic History of American Business, 1914-1970. Westport, Conn., Greenwood Press: Greenwood Press. ISBN 978-0-8371-6404-5. OCLC 488208.