Inertia coupling
Inertia coupling is a potentially lethal phenomenon of high-speed flight in which the inertia of the heavier fuselage overpowers the aerodynamic stabilizing forces of the wing and empennage. The problem became apparent as single-engine jet fighter aircraft were developed with narrow wing spans that had relatively low roll inertia, relative to the pitch and yaw inertia dominated by the long slender high-density fuselage.[1]
Description
Inertial coupling occurs when an aircraft such as that described above is quickly put into a roll, resulting in violent pitching and yawing, and loss of control as the aircraft rotates on all three axes.
The phenomenon itself is not aerodynamic, and is caused by general conservation of angular momentum acting on mass whose radial distribution is not symmetric about the axis of rotation. It can be visualized by imagining a uniform long rod, at each end of which is a perpendicular extension, each pointing opposite the other. (If the rod is horizontal, one points up and the other points down.) At the end of each extension is a weight. The extensions and weights are identical, so the center of mass and the axis of rotation along the length of the rod are unaffected by the weights. If the rod is then spun about its axis, the centrifugal forces on the two weights will cause the entire assembly to tilt relative to its initial axis of rotation.
Although a typical jet aircraft has most of its mass distributed close to its centerline, and the aerodynamics in planes designed to be stable (such that small fluctuations in control tend to return it to attitude equilibrium) provide some stabilization, it is important to remember that aircraft realistically always fly with a small non-zero random rate of yawing and pitching. Inertia coupling on an aircraft usually manifests itself as a downward pitching; rolling causes the tail mass to be flung upward and thus the nose to tip down. The pitching can in turn cause gyroscopic yawing.
Early history
Inertia coupling was essentially unknown before the introduction of high-speed jet aircraft. Prior to this time aircraft tended to be wider than long, and their mass was generally distributed closer to the center of mass. This was especially true for propeller aircraft, but equally true for early jet fighters as well. It was only when the aircraft began to sacrifice aerodynamic surface area in order to lower drag, and use longer fineness ratios that lowered supersonic drag, that the effect became obvious. In these cases the aircraft was generally much more tail-heavy, allowing its gyroscopic effect to overwhelm the small control surfaces.
Inertia coupling killed pilot Mel Apt in the Bell X-2 and nearly killed Chuck Yeager in the X-1A.[2] It was also extremely obvious in the X-3 Stiletto, and flight tests on this aircraft were used to examine the problem. The first two production aircraft to overtly experience this phenomenon, the F-100 Super Sabre and F-102 Delta Dagger, were modified to increase wing and tail area and were fitted with augmented control systems. To enable pilot control during dynamic motion maneuvers, for instance, the tail area of the F-102A was increased 40%. In the case of the F-101 Voodoo, a stability augmentation system was retrofitted to the A models to help combat this problem.
References
- ^ Hurt, H. H., Jr. (1965) [1960]. Aerodynamics for Naval Aviators. U.S. Government Printing Office, Washington D.C.: U.S. Navy, Aviation Training Division. p. 315. NAVWEPS 00-80T-80.
{{cite book}}: Unknown parameter|month=ignored (help)CS1 maint: multiple names: authors list (link) - ^ Dr. James Young. "The story of Chuck Yeager's wild ride in the Bell X-1A".